anchor

Detailed Product Description

      The anchor is comprise capsule and rod(bolt).The anchor capsule is an epoxy-acrylic resin, styrene free, sands, and a benzoyl peroxide catalyst. They are non-expansive, stress-free anchors, and can be installed at closer center and edge spacings without reducing concrete load bearing capacity.Installation parameters:  

Chemical Anchor Capsule	Chemical Anchor Stub: Steel 5. 8 / stainless steel 316	Drill hole diameter	Depth of drill hole	Maximum Anchor thickness
Description	L [mm]	D [mm]	H [mm]	H [mm]
M10	130	12	90	20
M12	160	14	110	25
M16	190	18	125	35
M20	260	22	170	65
M24	300	28	210	65
M30	380	35	280	65

Average destroy load of individual anchor bolts:    Unit: KN

Chemical anchor			M10	M12	M16	M20	M24
Tension	C 30 concrete	Steel 5. 8	32.2	45.8	71.8	128.4	188.6
		Stainless steel 316	36.8	58.8	76.9	137.7	196.6
Shear	C 30 concrete	Steel 5. 8	19.7	29.8	48.0	78.8	111.6
		Stainless steel 316	27.4	36.6	63.7	100.8	119.6

Individual design load of anchor bolts: Unit: KN

Chemical anchor			M10	M12	M16	M20	M24
Tension	C 30 concrete	Steel 5. 8	10.9	16.2	23.1	42.7	59.6
		Stainless steel 316	10.9	16.2	23.1	42.7	59.6
Shear	C 30 concrete	Steel 5. 8	12.1	17.7	33.0	51.4	74.2
		Stainless steel 316	13.1	19.0	35.3	55.2	44.2

Spacing and Edge distance

			M10	M12	M16	M20	M24
Effective anchorage depth	hef	[mm]	90	110	125	170	210
Characteristic spacing	scr,N	[mm]	220	270	310	420	520
Characteristic edge distance	ccr,N	[mm]	110	135	155	210	260
Minimum spacing	smin	[mm]	90	110	125	170	210
Minimum edge distance	cmin	[mm]	45	55	65	85	105
Min. thickness of concrete slab	hmin	[mm]	140	160	175	220	260

 

Installation:
1. Prefix drill hole using drill, maintaining the specified drill hole depth and drill hole diameter
2. Remove drill dust completely
3. Insert the right glass resin capsule
4. Turn stud into drill hole using drill attachment. Stop when the setting depth specified reaches the surface
5. The anchor is correctly fixed when the setting depth specified flushes with the drill hole surface and excess mortar is discharged from the hole. If excess mortar fails to come out of the drill hole, the anchor stud must be removed immediately
6. An additional capsule must be inserted along side to the previous capsule and the same procedure repeated to fix the anchor however at all times. Excess mortar shall be discharged from the hole to indicate proper fixing
7. Connect fixture at the end of the curing and tighten with nut the washer. After the appropriate setting time tighten the fixing and apply the work load.